Specifications

Chapter 11: Removal and Replacement Procedures --- Paper Transportation
11-3
RRP 3.1 Link Assembly
Removal
1. Open the Rear Cover (RRP 1.1).
2. Remove the Top Cover (RRP 1.2).
3. Remove the Left Cover (RRP 1.3).
4. Open the Front Cover and remove the two tapped 8mm silver screws securing the Link
Assembly to the printer frame just below the fuser area .
5. Use a screwdriver to pry open the link spring that holds the Link Assembly to the front cover .
6. Remove the Link Assembly.
Replacement
1. Snap the end of the Link Assembly arm into the spring on the front cover.
2. Position the other end of the Link Assembly against the printer frame just below the fuser
area.
3. Line up the alignment bosses on the Link Assembly with the holes in the frame.
4. Secure the Link Assembly to the frame with two tapped 8mm silver screws.