Specifications

Chapter 10: Removal and Replacement Procedures --- Feeder Assembly
10-19
RRP 2.9 Size Spring
NOTE: If this printer has an optional Feeder Assembly, remove it before starting
this RRP (see RRP 2.1).
Removal
1. Remove the Paper Cassette.
2. Remove the Feeder Assembly (RRP 2.1).
3. Remove the two tapped 8mm gold screws securing the Feeder Tie Plate.
4. Remove the plate.
5. Remove the five screws (two 8mm silver screws on top, and three tapped 8mm
silver screws on the bottom) securing the Feed Housing R.
6. Remove the Feed Housing R.
7. Remove Feeder PWB (RRP 2.8).
8. Remove the 8mm silver screw securing the Size Spring to the Feeder Assembly,
and remove the spring .
Replacement
1. Position the Size Spring against the Feeder Assembly. Line up the two alignment
holes in the spring with the two alignment bosses on the assembly.
2. Secure the Size Spring to the Feeder Assembly with a 8mm silver screw.
3. Reinstall the Feeder PWB.
4. Reinstall the Feed Housing R. Secure it with two 8mm screws on the top, and
three tapped 8mm silver screws on the bottom.
5. Position the Feeder Tie Plate. Secure it with two 8mm tapped gold screws.