Specifications

Chapter 10: Removal and Replacement Procedures --- Feeder Assembly
10-17
RRP 2.8 Feeder PWB
NOTE: If this printer has an optional Feeder Assembly, remove it before starting
this RRP (see RRP 2.1).
Removal
1. Remove the Paper Cassette.
2. Remove the Feeder Assembly (RRP 2.1).
3. Remove the two tapped 8mm gold screws securing the Feeder Tie Plate.
4. Remove the plate.
5. Remove the five screws (two 8mm silver screws on top, and three tapped 8mm
silver screws on the bottom) securing the Feed Housing R.
6. Remove the Feed Housing R.
7. Remove the two 8mm silver screws securing the Feeder PWB, and pull the PWB
away from the frame .
8. Disconnect the three connectors P/J116, P/J201, and P/J202 from the Feeder
PWB, and remove the PWB.
Replacement
1. Position the Feeder PWB close to the Feeder Assembly.
2. Plug connectors P/J116, P/J201, and P/J202 in to the Feeder PWB.
3. Secure the Feeder PWB to the Feeder Assembly with two 8mm silver screws.
4. Reinstall the Feed Housing R. Secure it with two 8mm screws on top, and three
tapped 8mm silver screws on the bottom.
5. Reposition the Feeder Tie Plate. Secure it with two 8mm tapped gold screws.