Specifications

Chapter 10: Removal and Replacement Procedures --- Feeder Assembly
10-15
RRP 2.7 No-Paper Actuator
NOTE: If this printer has an optional Feeder Assembly, remove it before starting
this RRP.
Removal
1. Remove the Paper Cassette.
2. Remove the Feeder Assembly (RRP 2.1).
3. Remove the two tapped 8mm gold screws securing the Feeder Tie Plate.
4. Remove the plate.
5. Remove the five screws (two 8mm silver screws on top, and three tapped 8mm
silver screws on the bottom) securing the Feed Housing R.
6. Remove the Feed Housing R.
7. Rotate the No-Paper Actuator counter clockwise to the position shown in the
illustration .
8. Remove the No-Paper Actuator from the Feeder Frame Assembly.
Replacement
1. Slide the small end of the No-Paper Actuator into the hole in the tab at the center
of the Feeder Assembly.
2. Rotate the No-Paper Actuator counter clockwise to the position shown in the
illustration.
3. Rotate the No-Paper Actuator clockwise. Make sure it clears the sensor on the
Feeder PWB.
4. Reinstall the Feed Housing R. Secure it with two 8mm silver screws on top, and
three tapped 8mm silver screws on the bottom.
5. Position the Feeder Tie Plate. Secure it with two 8mm tapped gold screws.