Specifications

Chapter 10: Removal and Replacement Procedures --- Feeder Assembly
10-13
RRP 2.6 Turn Roll Assembly
NOTE: If this printer has an optional Feeder Assembly, remove it before starting
this RRP (see RRP 2.1).
Removal
1. Remove the Paper Cassette.
2. Remove the Feeder Assembly (RRP 2.1).
3. Remove the two tapped 8mm gold screws securing the Feeder Tie Plate.
4. Remove the plate.
5. Remove the five screws (two 8mm silver screws on top, and three tapped 8mm
silver screws on the bottom) securing the Feed Housing R.
6. Remove the Feed Housing R.
7. Remove the five screws (two 8mm silver screws on top, and three tapped 8mm
silver screws on the bottom) securing the Feed Housing L.
8. Remove the Feed Housing L.
9. Remove the E-Ring located on the left end of the Turn Roll Assembly. Slide the
shaft out of the Feeder Assembly. Do not remove the bearing that supports the
left end of the shaft .
Replacement
1. Slide the Feed Roll Assembly through the slot on the right side of the Feed
Assembly.
2. Slide the free end of the Feed Roll Assembly shaft into the bearing on the left
side of the Feed Assembly.
3. Position the bearing on the right end of the shaft so the flat sides mesh with the
cutouts on the Assembly. Press the bearing into the cutout. Make sure both
bearings are seated correctly.
4. Place the E-Ring on the left end of the shaft.
5. Slide the Gear IN and Gear OUT back onto their respective shafts.
6. Reinstall the Feed Housing R and the Feed Housing L. Secure each with two
8mm screws on top, and three tapped 8mm silver screws on the bottom.
7. Position the Feeder Tie Plate. Secure it with two 8mm tapped gold screws.