Specifications

Chapter 10: Removal and Replacement Procedures --- Feeder Assembly
10-11
RRP 2.5 Feed Roll
NOTE: If this printer has an optional Feeder Assembly, remove it before starting
this RRP.
Removal
1. Remove the Paper Cassette.
2. Remove the Feeder Assembly (RRP 2.1).
3. Rotate the Feed Shaft so the flat side of the Feed Rolls are facing you.
4. Take the Feed Roll between your fingers and carefully rock it while pushing it off
of the shaft .
Replacement
1. Rotate the Feed Shaft so the wide ends of the locating holes in the shaft are
facing you.
2. Insert the locating pin on the Feed Roll into the locating hole in the shaft .
3. Push the Roll onto the shaft. It will snap into place.