Specifications

Chapter 10: Removal and Replacement Procedures --- Feeder Assembly
10-5
RRP 2.2 Feed Solenoid
NOTE: If this printer has an optional Feeder Assembly, remove it before starting this
RRP.
Removal
1. Remove the Paper Cassette.
2. Remove the Feeder Assembly (RRP 2.1).
3. Remove the two tapped 8mm gold screws securing the Feeder Tie Plate .
4. Remove the plate.
5. Remove the five screws (two 8mm silver screws on top, and three tapped 8mm
silver screws on the bottom) securing Feed Housing R.
6. Remove Feed Housing R.
7. Remove the Gear IN and Gear OUT by sliding them forward and off of their
shafts.
8. Remove the two 8mm silver screws securing the Feeder PWB, and pull the PWB
away from the frame.
9. Unplug P/J 201 from the Feeder PWB.
10. Remove the 8mm silver screw securing the Feed Solenoid to the Feeder
Assembly.
11. Remove the Solenoid.
Replacement
1. Secure the Feed Solenoid to the Feeder Assembly with an 8mm silver screw.
2. Plug P/J 201 into the Feeder PWB.
3. Secure the Feeder PWB to the Feeder Assembly with two 8mm silver screws.
4. Slide the Gear IN and Gear OUT back onto their respective shafts.
5. Reinstall the Feed Housing R. Secure it with two 8mm silver screws on top, and
three tapped 8mm silver screws on the bottom.
6. Position the Feeder Tie Plate. Secure it with two 8mm tapped gold screws.