Specifications

Chapter 10: Removal and Replacement Procedures --- Feeder Assembly
10-3
RRP 2.1 Feeder Assembly
Removal
1. Remove the Paper Cassette.
2. Position the printer on its Rear Cover .
3. Hold the printer steady while you remove the four 6mm silver screws securing
the Feeder Assembly to the bottom of the printer frame.
4. Carefully pull the assembly a few inches away from the printer, exposing the
wiring harness connecting the two section .
5. Unplug P/J 115 from the Feeder PWB.
6. Remove the Feeder Assembly.
7. Return the printer to a normal upright position.
Replacement
1. Position the printer on its rear cover.
2. Hold the printer steady while you position the Feeder Assembly close to the
bottom of the printer frame.
3. Carefully plug P/J 115 into the Feeder PWB.
4. Press the Feeder Assembly against the bottom of the printer frame. Align the
holes on the feeder with the aligning bosses on the frame.
CAUTION: Do not pinch the wiring harness between the Feeder Assembly and the
printer frame.