Specifications

Chapter 9: Removal and Replacement Procedures --- Covers
9-9
RRP 1.4 Right Cover
Removal
1. Open the Rear Cover (RRP 1.1).
2. Remove the Top Cover (RRP 1.2).
3. Use a screwdriver to pry up the cover latch located at the base of the
fuser assembly .
4. Remove the Right Cover.
Replacement
1. Insert the three plastic tabs located at the bottom of the Right Cover into
the corresponding slots in the printer frame.
2. Swing the Right Cover up until the slotted plastic latch at the top of the
cover snaps into place at the base of the fuser assembly.