Specifications

Chapter 9: Removal and Replacement Procedures --- Covers
9-7
RRP 1.3 Left Cover
Removal
1. Open the rear cover (RRP 1.1).
2. Remove the Top Cover (RRP 1.2).
3. Use a screw driver to pry up the Left Cover latch located at the base of
the fuser assembly .
4. Remove the Left Cover.
Replacement
1. Insert the three plastic tabs at the bottom of the Left Cover into the
corresponding slots in the printer frame.
2. Swing the Left Cover up until the slotted plastic latch at the top of the
cover snaps into place at the base of the fuser assembly.