Specifications

Chapter 9: Removal and Replacement Procedures --- Covers
9-3
RRP 1.1 Rear Cover
Removal
1. Remove the power cord from the back of the printer.
2. Press down on the two plastic tabs at the top of the Rear Cover, and
swing the cover down and open.
3. Press the center tabs of the two plastic hinges located at the bottom of
the open Rear Cover. Remove the cover.
Replacement
1. Push the plastic hinges, located at the bottom of the cover, into the slots
at the bottom of the printer back plate. They will snap into place.
2. Swing the Rear Cover up and closed.