Specifications

Chapter 7: Using the Diagnostic Tool
7-37
Printer conditions and responses for Fault/Status codes continued
Code
Conditions that caused
the fault
How the printer responds to the fault How to clear the
LCD
J3
The CRU switch is not
actuated.
The printer shuts down the Main
Motor, ROS, and Fuser functions.
Install or
reposition the EP
Cartridge.
P1
A Set Pause
command
stopped the Fuser
and ROS
controls.
The printer shuts down the Fuser
functions.
Input a Reset
Pause
command.
C3
1. All of the Paper
Size Switches are
deactuated
(Standard Model
printer).
2. All of the Paper
Size Switches in
both paper
feeders are
deactuated
(Optional Feeder
Assembly).
The printer shuts down the Main
Motor, ROS, and Fuser functions.
Install the Paper
Cassettes.
C5
The selected paper
feeder is empty. (The
No Paper Sensor is
actuated).
The printer completes the cycle, and
stops.
Load paper into
the empty
cassette.
CX
The paper size
detected by the
Registration Sensor is
different that the
preset size in ROM.
(MBF model only).
The printer displays the message
PAPER SIZE ERROR on the LCD.
Change the paper
size in the MBF
tray, or reset the
parameter in
Configuration
Mode.
J5
The printer made ten
prints since the Toner
Sensor was actuated.
The printer displays the message EP
CARTRIDGE NEED TO REPLACE
on the LCD.
Replace the EP
Cartridge.