Specifications

Chapter 7: Using the Diagnostic Tool
7-36
Printer conditions and responses for Fault/Status codes continued
Code Conditions that caused the fault How the printer responds to the
fault
How to clear the LCD
E4
A sheet of paper does not deactuate
the Exit Sensor in the specified time
after actuation of the Registration
Sensor.
A sheet of paper is actuating the Exit
Sensor when the printer is switched
ON.
A sheet of paper is actuating the Exit
Sensor when you actuate the
interlock.
A sheet of paper is actuating the Exit
Sensor during the PowerOn
sequence or during the Recovery
Routine.
The printer shuts down the
Main Motor, ROS, and Fuser
functions.
Open the Front Transport
Assembly.
Remove the jammed
paper.
Close the Front
Transport Assembly.
E3
A sheet of paper does not deactuate
the Exit Sensor in the specified time
after actuation of the Registration
Sensor.
The printer shuts down the
Main Motor, ROS, and Fuser
functions.
Open the Front Transport
Assembly.
Remove the jammed
paper.
Close the Front
Transport Assembly
E2
A sheet of paper actuates the
Registration Sensor too soon after
the start of paper feed.
A sheet of paper does not actuate
the Registration Sensor in the
specified time after the start of paper
feed. (Misfed Paper Jam).
A sheet of paper is actuating the
Registration Sensor when the printer
is switched ON.
A sheet of paper is actuating the
Registration Sensor during PowerOn
sequence or during the Recovery
Routine.
The printer shuts down the
Main Motor, ROS, and Fuser
functions.
Open the Front Transport
Assembly.
Remove the jammed
paper.
Close the Front
Transport Assembly.