Specifications

Chapter 7: Using the Diagnostic Tool
7-32
Configuration Mode code table continued
Code LCD DISPLAY MESSAGE
(Function of the routine)
Parameters [Factory default]
Contents of the parameter
Are changes possible?
4 REG.PROCESS 2
(Sets the lead edge
registration for paper fed
from Tray 2)
0~F (16 steps)[8]
0=Narrowest lead edge
registration gap
F=Widest lead edge
registration gap
(approximately 0.56mm per
step)
YES,depending on the
model of printing used
5 REG.PROCESS 3
(Sets the lead edge
registration for paper fed
from the MBF)
0~F (16 steps)[8]
0=Narrowest lead edge
registration gap
F=Widest lead edge
registration gap
(approximately 0.56mm per
step)
YES, depending on the
model of printing used
6 REG.SCAN 1
(Sets the side edge
registration for paper fed
from Tray 1)
0~8 (9 steps) [4]
0=Narrowest side edge
registration gap
8=Widest side edge
registration gap
(approximately 0.56mm per
step)
YES, depending on the
model of printing used
7 REG.SCAN 2
(Sets the side edge
registration for paper fed
from Tray 2)
0~8 (9 steps) [4]
0=Narrowest side edge
registration gap
8=Widest side edge
registration gap
(approximately 0.56mm per
step)
YES, depending on the
model of printing used
8 REG.SCAN 3
(Sets the side edge
registration for paper fed
from MBF)
0~8 (9 steps) [4]
0=Narrowest side edge
registration gap
8=Widest side edge
registration gap
(approximately 0.56mm per
step)
YES, depending on the
model of printing used
9 FUSER TEMP.SET
(Sets the rated fuser
temperature)
0~F(16 steps) [8]
0=Lowest rated temperature
F=Highest rated temperature
(approximately 4.0°c per step)
YES