Specifications

Chapter 7: Using the Diagnostic Tool
7-30
To select a Configuration Code
1. Enter Configuration Mode.
The default is Configuration Code 0.
2. Repeatedly press [2] to select other codes.
The first digit following NV changes.
3. Stop when the LCD displays the desired Configuration Code.
4. Enter the Code parameter.
To input code parameters
1. Press [1] to select Configuration Code parameters.
The second digit following the NV changes.
2. Stop when the LCD displays the desired parameter.
The LCD displays the parameter and writes it to ROM.
Using the Configuration Code G "Test Print"
Warning: Make sure the printer has all the covers in place when you
perform NV G.
NV G performs the same function as Printing Test Mode except NV G
generates a single test pattern, then stops.
1. Enter Configuration Mode.
2. Press [2] to select NV G
The first digit following NV changes to G.
3. Press [1].
The printer generates a grid test pattern, then stops.
Note: The printer will not generate a test print if it detects a fault when you
press [1], or if the printer is in Power-On Sequence. The LCD displays a
Fault Code for about two seconds, then returns to the status displayed
before you pressed [1].