Specifications

Chapter 7: Using the Diagnostic Tool
7-26
DG 00 SIZE SENSOR
This Diagnostic code checks the setting of the switch combination of the Paper Size Switches on
Tray 1 or Tray 2.
To run DG 00 SIZE SENSOR:
1. Enter Diagnostics Mode.
2. Repeatedly press [2] until the LCD displays
DG 00 SIZE SENSOR.
3. Press [1] to start the test.
The LCD displays a two digit hexadecimal number that corresponds to
the switch combination for Tray1
4. Press [1] again to display the switch combination for Tray 2.
Use the following table to determine the Paper Size Switch
combinations. 0 is OFF. 1 is ON
Sheet Size SW1 SW2 SW3 SW4 HEX number Switch Setting
No Tray installed 00(00~07)
No Cassette installed 0 0 0 0 0F(08~15)
MONARCH 0 0 0 1 1E(16~24) 2
LEGAL 13" 0 0 1 0 2C(25~32) 9
POSTCARD 0 0 1 1 3B (33~41) B
COM10 0 1 0 0 49 (42~4F) F
A4 (SEF) 0 1 0 1 58 (50~5E) 4
C5 0 1 1 0 66 (5F~6D) E
DL 0 1 1 1 75 (6E~7B) D
EXECUTIVE (SEF) 1 0 0 0 83 (7C~8A) 5
B5(SEF) 1 0 0 1 91 (8B~98) A
LEGAL 14" 1 0 1 0 A0(99~A7) 8
1 0 1 1 AE(A8~B5)
1 1 0 0 BD(B6~C4)
LETTER (SEF) 1 1 0 1 CB(C5~D3) 6
1 1 1 0 D9(D4~E1)
A5(SEF) 1 1 1 1 E8(E2~FF) 7
Nonstandard (MAX 14") fed
from MFB
0,1,3
.
Table continued on next page