Specifications

Chapter 7: Using the Diagnostic Tool
7-15
DG 08 FUSER TEMP
This Diagnostic code displays the current temperature of the fuser.
To run DG 08:
1. Enter Diagnostics Mode.
2. Repeatedly press [2] until the LCD displays
DG 08.
3. Press [1] to start the test.
The LCD displays a two digit temperature code. Use the following table
to determine the temperature setting. The temperature code displayed in
the LCD corresponds to the 16 temperature steps available in
Configuration Mode Code 9.
Temperature Code
Displayed in LCD for 12
PPM
Configuration Mode
Code 9 Temperature
Setting
Temperature Code
Displayed in LCD for
12 PPM
Configuration Mode
Code 9 Temperature
Setting
C6 0 9E 8
C1 1 99 9
BC 2 94 A
B7 3 8F B
B2 4 8A C
AD 5 85 D
A8 6 80 E
A3 7 7B F