Specifications

Chapter 7: Using the Diagnostic Tool
7-10
To Test This... Enter This DG Code...
The LCD Displays...
The Pick-Up Solenoid 80
SOLENOID TRAY 0
The Feed Solenoid f 81
SOLENOID TRAY 1
The Optional Feed Solenoid 86
SOLENOID TRAY 2
The Feed Assembly Turn Solenoid 84
T CLUTCH UPPER
The Optional Feed Assembly Turn Solenoid 85
T CLUTCH LOWER
Main Drive Motor 90
MOTOR MAIN
HVPS A/C voltage to BCR 91
HVPS (C. ROLL AC)
HVPS D/C voltage to BCR 92
HVPS (C ROLL DC)
HVPS D/C voltage to Magnet Roll 93
HVPS (DEV BIAS)
HVPS neg D/C voltage to BTR 94
HVPS (T ROLL -)
HVPS pos D/C voltage to BTR 95
HVPS (T TOLL +)
Exit the current diagnostic mode 00
EXIT
Selecting a Diagnostic Code:
The default diagnostic Code is DG 30 (Total Print Count). To select other codes:
1. Press [2]. The number following DG in the LCD display changes.
2. Repeatedly press [2] to step through the diagnostic codes.
DG codes are displayed in the order they appear in the Diagnostic Code Table.
NOTE: When running any diagnostic test, except DG 02, press [2] to get into DG00 the press [1]
to exit the test and enter another DG.