Specifications

Chapter 7: Using the Diagnostic Tool
7-7
Printing Test Mode
The Printing Test Mode lets you to print a grid pattern test print, at the highest printer.speed. The
test grid is made up of black lines that are one dot wide, spaced at 128-dot intervals, and running
horizontally and vertically across the page. There is a 4mm +/- 1mm border of clear paper around
the test grid.
The printer, not the print controller, generates the test print.
Printing Test Mode Options
There are no options in Printing Test Mode.
To enter Printing Test Mode
Warning: Make sure all covers are in place on the printer before entering Printing Test
Mode.
1. Hold down [2] and swich on printer Main Power.
2. Hold down [2] for 2 seconds.
3. Release the key.
While in Power-On sequence, the LCD displays the
Please Wait/Test Print mesage.
PLEASE WAIT
TEST PRINT 00
When the Power-On Sequence finishes, the LCD displays the Ready To Print/Test Print
message. The printer is now in Test Print Mode.
READY TO PRINT
TEST PRINT 00
1. Press [1] to start generating test prints.
NOTE: The ROS Assembly Scanner Motor continues to spin throughout the test. The Test Print
Count appears in the LCD message.
2. Press [1] again to stop generating the test prints.
3. To exit Printing Mode, switch off the Main Power.