Specifications

Chapter 6: FRU Replacement and Fault Isolation Procedures
6-17
6.2.7 Paper Jam between Feeder and Reg. Sensor: Fault
code E2 continued
18. FEED SOLENOID ANALYSIS
Use Diagnostic Tool test DG81, [DG86 for Tray 2], to check the Feed Solenoid.
Does the Feed Solenoid actuate?
Yes No
Go to Step 19. Go to Section 6.3.15 Feed Solenoid Failure.
19. FEED ROLL ASSEMBLY ANALYSIS
Use Diagnostic Tool tests DG81 [DG86 for Tray 2] and DG90 at the same time to check the
Feed Roll Assembly.
Does the Feed Roll feed paper from the cassette?
Yes No
Go to Step 20. Replace the Feed Roll Assembly.
20. TURN SOLENOID ASSEMBLY ANALYSIS
Use Diagnostic Tool test DG84 [DG85 for Tray 2] to check the Turn Solenoid. Does the Turn
Solenoid actuate?
Yes No
Go to Step 21. Go to Section 6.3.16 Turn Solenoid Failure.
21. TURN ROLL ASSEMBLY ANALYSIS
Use Diagnostic Tool tests DG90 and DG84 [DG85 for Tray 2] at the same time to check the Turn
Roll Assembly. Remove the Paper Cassette so you can observe the Turn Roll.
Does the Turn Roll rotate while in DG90 and stop when you enter DG84 (or DG85)?
Yes No
Go to Step 22. Replace the Turn Roll Assembly.