Specifications

Chapter 6: FRU Replacement and Fault Isolation Procedures
6-14
6.2.7 Paper Jam between Feeder and Reg. Sensor: Fault
code E2 continued
4. DRIVE ASSEMBLY ANALYSIS
Use Diagnostic Tool test DG90 to check the Drive Assembly.
Do the transmission gears rotate normally?
Yes No
Go to Step 5. Replace the Drive Assembly.
5. TAKE–AWAY ROLL ASSEMBLY ANALYSIS
Use Diagnostic Tool test DG90 to check the Take–Away Roll. Remove the Fuser Assembly and
toner (EP) Cartridge to observe the Take–Away Roll.
Does the Take–Away Roll rotate?
Yes No
Go to Step 6. Replace the Take–Away Roll Assembly.
6. PICK–UP ROLL ASSEMBLY ANALYSIS
Use Diagnostic Tool test DG90 to check the Pick–Up Roll. Remove the Fuser Assembly and
toner (EP) Cartridge to observe the Pick–Up Roll.
Does the Pick–Up Roll rotate?
Yes No
Go to Step 7. Replace the Pick–Up Roll Assembly.
7. Is the printer equipped with MBF?
Yes No
Go to Step 8. Go to Step 13.
8. ROM DATA ANALYSIS
(Fault code E2 appears only when Legal 13" and 14" paper is used.)
Does the parameter for Configuration Code A represent the paper size used in the Front
Tray Assembly?
Yes No
Go to Step 9 Correct the Parameter.