Specifications

Chapter 6: FRU Replacement and Fault Isolation Procedures
6-12
6.2.6 Paper Jam between Reg. Sensor and Exit Sensor:
Fault code E3 continued
4. LINK ASSEMBLY ANALYSIS
Does the LINK ASSEMBLY open the Drum Shutter when you close the Front Transport
Assembly?
Yes No
Go to Step 5. Replace the Link Assembly.
5. DRUM ANALYSIS
Use Diagnostic Tool test DG90 to check the toner (EP) Cartridge. Does the Drum rotate?
Yes No
Go to Step 6. Replace the toner (EP) Cartridge.
6. TRANSPORTATION CHUTE ASSEMBLY ANALYSIS
Use your hand to rotate the BTR toward you.
Does the BTR rotate smoothly?
Yes No
Go to Step 7. Replace the Transportation Chute Assembly.
7. BTR ANALYSIS
Remove the Fuser Assembly. Close the Front Cover. Use Diagnostic Tool test DG90 to check
the BTR rotation.
Does the BTR rotate?
Yes No
Go to Step 8. Replace the BTR Assembly.
8. TRANSPORTATION CHUTE ELIMINATOR ANALYSIS
Is the Eliminator clean?
Yes No
Go to Step 9. Clean or replace the Eliminator.
9. TRANSPORTATION CHUTE ELIMINATOR ANALYSIS
There is continuity between the Eliminator and RTN or SG?
Yes No
Go to Step 10. Replace the Eliminator.