. . . . . . . . . . . . . . . . . . . . . . . DEClaser 3500 Printer Internal Fax Modem Installation Guide EK-D350P-IG.A01 Digital Equipment Corporation Maynard, Massachusetts Part Number 194683-001 - 08/12/94 - - Saved by digital - Rev # - File Name FAXMODM2.
. . . . . . . . . . . . . . . . . . . . . . . First Printing, June 1994 Digital Equipment Corporation makes no representations that the use of its products in the manner described in this publication will not infringe on existing or future patent rights, nor do the descriptions contained in this publication imply the granting of licenses to make, use, or sell equipment or software in accordance with the description.
. . . . . . . . . . . . . . . . . . . . . . . FEDERAL COMMUNICATIONS COMMISSION NOTICE Class B Equipment FCC ID: A09-LN14X-FX This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
. . . . . . . . . . . . . . . . . . . . . . . This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled "Digital Apparatus," ICES-003 of the Department of Communications.
. . . . . . . . . . . . . . . . . . . . . . . If your telephone equipment causes harm to the telephone network, the telephone company may discontinue your service temporarily. If possible, they will notify you in advance. But, if advance notice is not practical, you will be notified as soon as possible. You will also be informed of your right to file a complaint with the FCC.
. . . . . . . . . . . . . . . . . . . . . . . CANADIAN REGULATIONS GOVERNING THE USE OF FACSIMILE DEVICES NOTE: The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective, operations, and safety requirements. The Department does not guarantee the equipment will operate to the user's satisfaction.
. . . . . . . . . . . . . . . . . . . . . . . ELECTROSTATIC DISCHARGE A discharge of static electricity from a finger or other conductor may damage circuit boards or other static-sensitive devices. This type of damage may reduce the life expectancy of the device. To prevent electrostatic damage, observe the following precautions: n n n n n Avoid hand contact by transporting and storing parts in static-safe containers.
. . . . . . . . . . . . . . . . . . . . . . . KIT CONTENTS n n n One Fax Modem board Screws Telephone cord with modular connection [RJ11 (USA) or CA11 (Canada)] n Fax software and documentation ITEMS NEEDED FOR INSTALLATION n n Internal Fax Modem Option Kit Nonmagnetic Phillips screwdriver CAUTION: To avoid electrostatic damage to the printer option and/or system controller board, follow the safety precautions outlined in "Electrostatic Discharge.
. . . . . . . . . . . . . . . . . . . . . . . ! WARNING: Turn the printer off and unplug the AC power cord before attempting to remove the system controller board. Failure to do so may result in an electrical shock or damage to the printer. WARNUNG: Schalten Sie den Drucker aus und ziehen Sie den Stecker des Netzteil-Adapters, bevor Sie die Systemsteuerungskarte ausbauen. Andernfalls besteht die Gefahr elektrischer Schläge oder einer Beschädigung des Druckers.
. . . . . . . . . . . . . . . . . . . . . . . STEP 2 DISCONNECT ALL CABLES FROM THE PRINTER. STEP 3 PRESS DOWN ON THE TABS TO OPEN AND LOWER THE REAR COVER. 10 Part Number 194683-001 - 08/12/94 - - Saved by digital - Rev # - File Name FAXMODM2.
. . . . . . . . . . . . . . . . . . . . . . . STEP 4 1 2 3 LOOSEN THE SCREWS AND REMOVE THE SYSTEM CONTROLLER BOARD. 1 Thumbscrews 2 System Controller Board 3 Rear Cover STEP 5 2 1 2 3 REMOVE THE BLANK PLATE COVERING AN INTERFACE CONNECTOR SLOT. 1 Blank Plate 2 Mounting Posts 3 Retaining Bracket 11 Part Number 194683-001 - 08/12/94 - - Saved by digital - Rev # - File Name FAXMODM2.
. . . . . . . . . . . . . . . . . . . . . . . STEP 6 J7 J9 PLUG THE MODEM INTERFACE CONNECTOR INTO LOCATION J7 OR J9 AND SECURE. Be sure that the screws are inserted through the insulator cover when securing the modem to the mounting posts. 12 Part Number 194683-001 - 08/12/94 - - Saved by digital - Rev # - File Name FAXMODM2.
. . . . . . . . . . . . . . . . . . . . . . . STEP 7 1 2 3 REINSTALL AND SECURE THE CONTROLLER BOARD AND CLOSE THE REAR COVER. 1 Thumbscrews 2 System Controller Board 3 Rear Cover STEP 8 RECONNECT ALL CABLES. 13 Part Number 194683-001 - 08/12/94 - - Saved by digital - Rev # - File Name FAXMODM2.
. . . . . . . . . . . . . . . . . . . . . . . STEP 9 CONNECT THE TELEPHONE CORD FROM A WALL JACK TO THE "LINE" JACK ON THE MODEM. ! WARNING: Always disconnect the Internal Fax Modem from the telephone system when installing options or when covers are removed from the printer. ADVERTISSEMENT : Déconnectez toujours le modem fax du système téléphoneque lorsque vous installez une option ou déposez le capot de l'imprimante.
. . . . . . . . . . . . . . . . . . . . . . . STEP 11 PLUG IN AND TURN ON (O) THE PRINTER. STEP 12 PRINT A HARDWARE REPORT. Using the printer control panel: 1. Press the Menu key. The printer is placed offline and in menu mode. 2. Go to the Reports menu to print a Hardware Report. 3. After printing the report, press Online (En ligne, Inlinea, En línea) to place the printer back online. 4. Verify that the Fax board is listed on the report.
. . . . . . . . . . . . . . . . . . . . . . . TROUBLESHOOTING If the option you just installed is not listed on the Hardware Report, you should: 1. Make sure that the Fax Modem is properly attached and firmly secured to the J7 or J9 connector. 2. Rerun the Hardware Report. 3. If the option is still not listed, move the Fax Modem board to the other connector (J7 or J9). 4. Rerun the Hardware Report. 5. If the Fax Modem is still not listed, contact your Authorized Service Provider.
