Installation guide

4.2 Parallel Interface Connection

This procedure uses an optional BC19M–10 parallel interface cable to

describe the parallel connection to the printer. You must order the BC19M–

10 parallel interface cable through DECdirect or through your Digital sales

representative.

CAUTION: Before connecting the parallel interface cable, be sure the host

device you are connecting to is turned off.

1. Plug the other end of the BC19M–10 cable into the parallel interface

connector on the printer.

Secure the cable by pressing the clips over the sides of the

connector.

mlo-005722

2. Plug the end of the BC19M–10 cable (with the two screws attached to

it) ﬁrmly into the parallel interface connector on the host device and

tighten the two screws.

4–4 Installation Guide