User`s guide
Table Of Contents
- Contents
- Tables
- Preface
- Introduction
- Getting Started
- 2.1 Overview
- 2.2 Hardware Required
- 2.3 Hardware Debug Features
- 2.4 Setting Up the SROM Serial Port Connection
- 2.5 Starting and Running the Mini-Debugger
- 2.6 Sample Session on the EB64
- 2.7 Sample Session on the EB64+ and the AlphaPC 6...
- 2.8 Sample Session on the EB66 and EB66+
- 2.9 Sample Session on the EB164
- 2.10 Sample Session on the AlphaPC 164
- 2.11 Sample Session on the AlphaPC 164LX
- 2.12 Onboard Machine Check Handler
- SROM Mini-Debugger Command Set
- Support, Products, and Documentation
- Index
SROM Mini-Debugger Command Set 3–15
User Commands
The next example shows that the cm command is not affected by this flag’s state and
prints out data whenever a mismatch occurs.
SROM> di
Disp OFF
SROM> cm
A> 500000
A> 500010
A> 600000
00000000.00500000: ffffffff
00000000.00600000: 0000ffff
00000000.00500004: 000f0000
00000000.00600004: ffff0000
00000000.00500008: 000f0000
00000000.00600008: 0000ffff
00000000.0050000c: 000f0000
00000000.0060000c: ffff0000