User`s guide
Table Of Contents
- Contents
- Tables
- Preface
- Introduction
- Getting Started
- 2.1 Overview
- 2.2 Hardware Required
- 2.3 Hardware Debug Features
- 2.4 Setting Up the SROM Serial Port Connection
- 2.5 Starting and Running the Mini-Debugger
- 2.6 Sample Session on the EB64
- 2.7 Sample Session on the EB64+ and the AlphaPC 6...
- 2.8 Sample Session on the EB66 and EB66+
- 2.9 Sample Session on the EB164
- 2.10 Sample Session on the AlphaPC 164
- 2.11 Sample Session on the AlphaPC 164LX
- 2.12 Onboard Machine Check Handler
- SROM Mini-Debugger Command Set
- Support, Products, and Documentation
- Index
SROM Mini-Debugger Command Set 3–3
User Commands
3.4 User Commands
This section contains a complete description and examples of the SROM
Mini-Debugger commands. The commands are listed in alphabetical order. The
Control Flags section in each command description lists the flags that affect the
behavior of the command if the flag is enabled.
Deposit/Examine Commands
dc Deposit internal CPU register.
dm Deposit data to memory location.
ec Examine internal CPU registers.
em Examine data in a memory location.
Print Commands
fl Print current state of flags.
pr Print contents of general purpose cpu registers.
Load/Execute Commands
rt Exit minidebugger.
st Start executing at specified address.
xb Begin execution of the last image loaded.
xm Load external image to memory.
Miscellaneous Command
sb Set base address.
Table 3–1 Command Summary
(Sheet 2 of 2)
Command Description