Technical data

Overview and Updates
Procedure 4
1. Install the impingement fan assembly and regulator cable by completing the following
steps:
A. Position the fan assembly into the system box and screw it in as shown.
B. Install cable (17−03815−01) into clip (12−37200−02) and attach clip through hole in
chassis as shown.
C. Remove the grommet and route the cable through the hole from which the grommet
was removed. Then route the cable through the grommet and install the grommet in its
original location.
D. Connect the impingement fan regulator cable (17−03815−01) to the impingement fan
and regulator as shown.
MLO-012112
Impingement Fan
70-30888-01
Impingement Fan
Regulator Cable
17-03815-01
Regulator Fan
Sense Cable
17-03816-02
Cable Clip
12-37200-02
Grommet
Screw
90-06039-02
Screws
90-00049-01
2-8