Technical data

Overview and Updates
Procedure 2
1. Remove the TURBOchannel option cards, and take note of the slot number that each
card was installed in.
2. Remove the 4 MMB modules (leaving SIMM cards installed).
3. On the right side of the enclosure (the side with the drive bays), disconnect the three
power cables and the cable to the light and switch module from the system module.
4. Remove the system module.
Procedure 3
1. Install the Model 900 system module.
2. Reassemble the system to its original configuration by performing the reverse of
procedure 2.
2-7