Instruction manual

Restarting and Testing the System
If You Have
Problems
If the displays show an error, follow these steps, using the wrist
strap:
1. Shut down the system hardware.
2. Make sure that all cables inside and outside the system are
properly reconnected.
3. Make sure that all modules are fully seated in their
connectors.
4. Make sure SCSI address switches and jumpers are set
correctly; no two drives should be set to the same SCSI
address.
If problems persist, refer to the troubleshooting section of your
DEC 3000 Model 800/800S/900 AXP Owner’s Guide, or contact
your Digital service representative.
Restoring the System 7–9