Instruction manual

Installation
5. Press the corners of the module over each mounting post
, seating the module connector with the connector on the
system module or I/O module, as shown in Figure 6–5. When
the module is seated, the pin latches will hold the module
in place. Secure the module, using two screws for every slot
.
Be sure to reconnect any pigtail connectors that were secured
by the screws. (For more information on pigtail connectors,
refer to the appendixes of the owner’s guide.)
Figure 6–5 Securing a TURBOchannel Module
MLO-008580
1
2
3
Completion
This completes installation of a TURBOchannel module.
6–8 TURBOchannel Options