Instruction manual

Removing a Removable-Media Drive

Removal Steps

To take a removable-media drive out of the system unit, follow

these steps:

1. Disconnect the SCSI and power cables from the system.

2. Release the two thumbscrews and remove the drive bracket

from the system.

3. Disconnect the SCSI and power cables from the drive.

4. Remove the two screws on each side of the drive bracket that

secure the drive.

5. Lift the drive out of the bracket.

6. Replace the bracket in the system unit and tighten the two

thumbscrews.

7. Reconnect the system SCSI and power cables.

8. Install the ﬁller plate.

Where to Go

from Here

If you Refer to

Have other options to add

inside the system,

The appropriate chapter.

Have no other options to add

inside the system,

Chapter 7 to replace the panels

and check the system.

Installing a Removable-Media Drive 3–15