Instruction manual

Installing a Removable-Media Drive

SCSI ID Setting

Before proceeding, make sure the drive you are installing is set

to an available SCSI ID address. To set or change the SCSI

ID address on the drive you are installing, refer to your drive’s

owner’s guide.

Overview

Removable-media drives are installed in a bracket in the front

of the system unit. These are the steps involved inpreparing to

install or replace a removable-media drive:

Step Action

1 Disconnect the power and SCSI cables.

2 Remove the bracket.

3 Identify the power and SCSI cables.

4 Connect the cables to the drive.

5 Place the drive in the bracket.

6 Position the cables.

7 Slide the bracket into the system.

8 Guide the bracket power cable.

9 Connect the cables to the system.

10 Tighten the thumbscrews.

11 Remove the blank ﬁller plate.

The following sections describe these steps.

3–2 Installing a Removable-Media Drive