Instruction manual

Removing Panels
WARNING:
Capacitor
Discharge
Allow 15 seconds from the time the system power is turned off
until you remove the system’s side panels. This delay gives the
power supply capacitors time to discharge safely.
CAUTION:
Static Damage
To avoid damage from static discharge after removing the side
panels and before touching anything inside the system, wear an
antistatic wrist strap. For information on using an antistatic
wrist strap, see Using an Antistatic Wrist Strap later in this
chapter.
Step 3:
Remove Left
Panel
If adding memory to the system, or if adding TURBOchannel
modules to the left side of the system unit (slots 0, 1, or 2);
remove the left side panel by pulling the tabs on the top edge
away and lifting the bottom edge out of the track , as shown
in Figure 2–8. Do not pull on the plastic part of the panel.
(TURBOchannel options may be installed in either the left or
right side.)
2–12 Preparing to Add Internal Options