Instruction manual

Displaying the Configuration
The show
config Display
If you are adding one or more TURBOchannel options, enter
the show config command to show the TURBOchannel modules
currently installed in the system.
Figure 2–4 shows an example of the display resulting from the
show config command.
Figure 2–4 The show config Display
>>> show config
DEC 3000 - M800
Digital Equipment Corporation
VPP PAL X5.41-82000101 - Built on 25-JUN-1994 00:00:00.00
TCINFO DEVNAM DEVSTAT
------ -------- ---------
CPU OK KN17-AA V1.x-SO86-IO62- DECchip 21064 P3.0
ASIC OK
MEM OK
8
7
NVR OK
SCC OK
NI OK
ISDN OK
6
SCSI OK
1-PMAZC-AA TC1
0-PMAGB-BE TC0
>>>
How to Read
the show
config Display
The TCINFO column lists the system’s TURBOchannel slots
and the modules in each. Note that slots 0 through 5 are for
TURBOchannel option modules (listed under DEVNAM as TC0
through TC5); slot 6 contains the built-in SCSI controller; and
slots 7 and 8 are for built-in system devices.
Note that if a TURBOchannel option module takes more than one
slot, only one of its slot designations will be shown in the display.
2–6 Preparing to Add Internal Options