Instruction manual

Displaying the Configuration
Displaying the Configuration
show device
Display
If you are adding one or more drives, enter the show device
command to show the drives installed in the system and their
status. You should get a display similar to what is shown in
Figure 2–2.
Figure 2–2 The show device Display
>>> show device
BOOTDEV ADDR DEVTYPE NUMBYTES RM/FX WP DEVNAM REV
------- ---- ------- -------- ----- -- ------ ---
ESA0 08-00-2B-1D-1E-EF , THICK
DKA0 A/0/0 DISK 1.05GB FX RZ26 T368
DKA100 A/1/0 DISK 426.25MB FX RZ25 0700
DKA200 A/2/0 DISK 426.25MB FX RZ25 0700
DKA300 A/3/0 DISK 426.25MB FX RZ25 0700
DKA400 A/4/0 RODISK ...... RM WP RRD42 4.3d
DKA500 A/5/0 DISK ...... RM RX26 0068
..HostID.. A/7 INITR
..HostID.. B/7 INITR
>>>
How to Read
the show
device Display
You should see the SCSI address for each drive in the ADDR
column, as shown in Figure 2–2. The drive model is shown
in the DEVNAM column. In this example, A/3/0 indicates an
address of 3 on the SCSI-A (internal device) bus for an RZ25
drive. B/7 indicates the initiator (SCSI controller) for the SCSI-B
(external device) bus.
You can have only one of each address (0-6) on each SCSI bus.
Use the show device output to choose an unused SCSI address
for drives you add to your system.
2–4 Preparing to Add Internal Options