User manual

Chapter 5 NICE 3200/3220 Reference and Installation

NICE 3200, NICE 3220, ICES 101, ICES 120, ICEB 3200 User Manual

5.9 Installing the HDD Mounting Kit

With front and back faceplates and top cover removed, it would be the

correct time to install the HDD kit if you wanted.

1. First, locate the HDD mounting holes on the ICEB 3200 carrier

board as shown below.

2. The HDD kit comes with a mounting bracket, a cable, some screws

and a plastic EMI shield. Since the plastic shield does not come

attached, you need to stick it on the bracket as shown in the gure

below. The same red arrows mark the corners of the plastic shield.

Connect the HDD bracket with 4 screws as shown below and apply

the EMI plastic shield. There are also 4 holes used to mount the HDD

to the bracket. It is okay to make holes through the EMI shield for

these screws, since it will overlap at least two of these HDD mounting

holes.

NOTE: If you would like to slide off the top cover, only the front

or back faceplate needs to be removed (only one). For example,

for installing a HDD you only need to remove the top cover of the

chassis.