Technical data

Server Software and Utilities
2-12
Perform the following steps to set a supervisor password:
1. Reboot the server and enter Setup.
2. Highlight the “
Security
” menu.
3. Highlight “
Set Supervisor Password
” and press [Enter].
4. Type in a seven (7) digit alpha-numeric supervisor password and then press
[Enter].
5. Retype the password as instructed and press [Enter]. (Notice that
“Supervisor Password Is” field now indicates Enabled.)
If desired, set a user password as follows:
1. Highlight “
Set User Password
” and press [Enter].
2. Type in a seven (7) digit alpha-numeric user password and then press
[Enter].
3. To confirm, retype the user password as instructed and press [Enter].
(Notice that “User Password Is” field now indicates Enabled.)
4. Press [Esc] then [Enter] twice to exit the BIOS Setup utility and to reboot the
server so changes immediately take effect.
The server runs the POST and then asks for the password, which has just been set.