Technical data

FRU Replacement
5-76
Removing and Replacing the Fault Status LED Assembly
1. Turn off the server.
2. Remove the front bezel.
3. Remove the two screws securing the server to the rack and then slide it out.
4. Remove the screw securing the top cover to the server.
5. Remove the top cover.
6. From inside the chassis, disconnect the cable from the fault status LED
assembly.
7. Press on the retaining tabs of the fault status LED assembly and then tilt it
forward to release it from the chassis.
8. Remove the fault status LED assembly from the chassis.
9. Replace the fault status LED assembly by performing the steps above in
reverse.