Technical data

FRU Replacement
5-74
Removing and Replacing the Operator Control Panel (OCP)
Assembly
1. Turn off the server.
2. Remove the front bezel.
3. Remove the two screws securing the server to the rack and then slide it out.
4. Remove the screw securing the top cover to the server.
5. Remove the top cover.
6. Disconnect the OCP cable from the main logic board.
7. Press down on the two retaining tabs on top of the OCP and then tilt it
forward to release it from the chassis.
8. Remove the OCP from the chassis.
9. Replace the OCP by performing the steps above in reverse.