Technical data

FRU Replacement
5-70
13. If the new main logic board does not have a battery/RTC, remove the
battery/RTC from the old main logic board and replace it on the new main
logic board.
Refer to the section “Replacing the Real Time Clock (RTC) Battery” at the end of this
chapter for more information.
14. Align the main logic board over the standoffs and then slide it toward the rear
of the chassis.
15. Secure the main logic board to the chassis using the previously removed
screws.
16. Using the side panel label as a reference, reconnect all cables to the main
logic board.
17. Using information recorded in step 7, install the expansion boards, processor
module, and video/Ethernet daughter card to their original configuration.
18. Reconnect all external and internal cable connections.
19. Replace and secure the top cover.
20. Slide the sever into the rack and then secure it using the two previously
removed screws.
21. Replace the front bezel.
22. Turn the server on.
23. Run the BIOS Setup utility to configure the server and restore the system
management information.