Technical data

FRU Replacement
5-35
DIGITAL Server 3220/3220R
Processor Module Switch Settings
The following table lists the switch settings of various processor speeds and does not
indicate processor availability. The switches are set correctly for the processor that
came with the server you purchased. You only need to change the processor switch
settings, that is SW1, should you upgrade to another processor. Figure 5-19 shows
the switch locations.
CAUTION:
Do not touch any electronic component unless
you are safely grounded. Wear a grounded wrist strap or
touch an exposed metal part of the server chassis. A static
discharge from your fingers can result in permanent
damage to electronic components.
Processor Speed SW1-1 SW1-2 SW1-3 SW1-4
350 MHz OFF OFF ON ON
400 MHz ON ON OFF ON
450 MHz OFF ON OFF ON
ON = switch down; OFF = switch up