Use & care guide

• DC-OUT DEFAULT VOLTAGE:

o By default, the DC-OUT setting is initialised at the lowest level of 4.2V

when the charger is first powered ON.

• VOLTAGE SELECTION:

Select 4.2V – to power devices accepting 3.0V – 4.5V input.

Select 6V – to power devices accepting 5.0V – 6.5V input.

Select 8.4V – to power devices accepting 7.0V – 9.0V input.

CAUTION:

•

When the DC-OUT function is used to power or charge external digital

devices, proceed with caution and ensure the selected voltage does

match with the required input voltage of the device. Failure to do so may

result in the damage of the device being powered.

•

In general most mobile phones and small sized digital devices are

charged using DC-OUT voltages of 4.2 and or 6V whereas bigger sized

devices such as portable DVDs, 2-Way Radios and Digital Video

Cameras are charged using the 8.4V setting.

• ALWAYS select DC-OUT voltage first and then plug in the device. Once

a device is plugged in, the selected voltage will be locked in and further

pressing of the DC-OUT button will have no effect. This feature ensures

accidental change of the DC-OUT voltage will not happen. Further

change in voltage can only be made by first unplugging the device and

reselecting a different voltage.

• DO NOT MODIFY OR WIRE the DC-OUT cable and try to connect it

directly to any type of battery packs or cells. Such actions are dangerous.

These batteries should only be charged within the devices from which

they are used in. Batteries not supported (such as notebook/laptop

battery packs) are outside the scope of this charger and should not be

forcibly charged in this charger.

ENGLISH