User guide

Dante Controller Software Installation
The DMP128PAT uses Dante Controller for Windows from Audinate to select and route
inputs and outputs for all connected DMP128ATs and other Dante-compatible audio
devices.
Download and install the latest version of Dante Controller for Windows from the included
software DVD or from the Dante Controller product page at www.extron.com .
Dante Network Audio Setup
The following procedure is recommended for configuring DMP128AT devices on a Dante
network. When configuring multiple DMP128AT models, follow this procedure for each
device, connecting them to the host computer one at a time.
100-240V ~ 0.6A MAX
50/60 Hz
LAN
EXP
RS-232
Tx Rx G
RESET
MIC +48V
5678
1234
8
4 1
1 2345G 6
1234
78910 G
11 12 13 14 15 G1617181920G
234
56 78
910
11 127
3
6
2
5
1
MIC/LINE INPUTS
OUTPUTS
DIGITAL I/O
REMOTE AT
DMP 128 C AT
PHONELINE
k
DMP 128 C AT
ef
gh ji
ab cdl
Figure 66. Rear Panel, AT Switch (
k
)
NOTE: A connection to both the Dante (AT) Ethernet switch and the DMP128 LAN
port is required for this setup.
• If the control computer has only one Ethernet port, connect it to a rear panel AT
port (see figure 66,
k
). Then connect a short Ethernet cable from the LAN port
(see figure 66,
i
) to an unused AT port (see figure 66,
k
).
• Alternately use an Ethernet switch to connect the control computer to both the
LAN and AT ports.
1. Connect the control computer to an AT (Dante)
port on the DMP128. Also connect the control
computer to the DMP128 LAN port.
2. Start DSPConfigurator in Live mode (see
Selecting Live Mode and Pushing or Pulling
Data on page90).
3. From the DSP Configurator menu bar, select
Tools > Device Settings (see figure 67,
right).
Figure 67. Tools, Device Settings
DMP128 • Dante Installation and Operation 113