User`s manual

OSD

SYTEM SETUP

Set Home Position?

When you replace the camera block or the orientation of camera

is changed due to maintenance operations, it is very difficult to

maintain the same pan orientation. Therefore, all function data

depending on pan orientation such as preset, scan, pattern, group

and privacy zone mask are not useful any more accordingly.

However, even in this case, you can reuse the data if you redefine

set home position on the previous home position.

SET NORTH DIRECTION

By using joystick, move the camera to the desired north

position and press enter (near/save).

The direction will be displayed in the screen

Direction will be displayed from:

N(North) / S(South) / E(East) / W(West) / NE(Northeast) /

NW(Northwest) / SE(Southeast) / SW(Southwest).

SET HOME POSOTION

- - - - - - - - - - - - - - - - - - - - - - - - - - -

MOVE TO TARGET POSITION

[NEAR:SELECT/FAR:CANCEL]

0/0/x1/E

SET NORTH DIRECTION

- - - - - - - - - - - - - - - - - - - - - - - - - - -

MOVE TO TARGET POSITION

[NEAR:SELECT/FAR:CANCEL]

0/0/x1/N

SET HOME POSITION

Home position means the origin of pan angle calculation.

The value of pan angle displayed on the screen is based on

this home position.

By using joystick, move the camera to the desired position

and press near key.

Home is not effective to tilt angle.

If you change the location of the home position, all horizontal

location of functions such as preset, scan, pattern, group and

privacy zone mask will be shifted based on the changed home

position.

If there are no setup for those functions like preset, pattern,

scan, group camera will automatically move to home position

after rebooting.

If power up action is set to be on, camera will continue the

function which is executed lastly after rebooting.

[NEAR:SELECT/FAR:CANCEL]

0/0/x1/N