Technical data

Utility Software for MS-DOS
CP 486 ⋅ 00/14 VIPA GmbH 95
From this master now files for the two EPROMs must be generated. Therfor the program SDGEN is
called up and the following parameters are entered:
C:\SD\SDGEN
EPROM-SIZE in Bit (0,512,1M,2M,4M,8M): 4M
SPLITTED IN ODD-EVEN (Y/N): Y
SOURCE DRIVE (A: .... F:) : D:
TARGET-FILE NAME (max. 8 char.) : EPROM
The program generates the files EPROM.O00 and EPROM.E00. Hereby it refers to binary files for
the EPROM programming device. Every file belongs to an EPROM. These EPROMs are to be
programmed. Accordingly the SRAMs are removed from the silicon disk bases, and the
programmed EPROMs installed into the silicon disk bases as follows:
EPROM.E00 in IC4 (even)
EPROM.O00 in IC3 (odd)
After the restart and boot, the storage media generated in the moment is available as drive E:.
If the silicon disk ROM is set to address C0 0000hex as drive A: in the BIOS-Setup, then this
program memory can also be used for booting.