Technical data

Assignment of Plugs and Sockets
CP 486 ⋅ 00/14 VIPA GmbH 37
3. Assignment of Sockets and Plugs
The figures show plugs or sockets when regarding the module in the card cage. The top in the figure
is also the top on the plug.
3.1 15-pin SubD-Socket for Connecting the Monitor
15
10
5
14
9
4
13
8
3
12
7
2
11
6
1
Socket assignment is specified by the DIP switch SW2 (5,6,7,8), (section 2.2).
Mode --------------------- analog modes ------------------------- ------------- digital modes
**
----------------
VGAcolor VGAmono RGB BAS EGA/CGA EGA mono EGA-EL
Cab.length 5-10m 5-10m 250m 250m 1.5m 1.5m 1.5m
PIN-NO.
01 red - red - red - clock
02 green video green+sync int.+sync green intensity el-hsync
03 blue - blue - blue video intensity
04 ------ not used--------------------------------------------------------------------------------------------------------------------------------------
05 ------ Gnd---------------------------------------------------------------------------------------------------------------------------------------------
06 ------ Gnd red----------------------------------------------------------------------------------------------------------------------------------------
07 ------ Gnd green-------------------------------------------------------------------------------------------------------------------------------------
08 ------ Gnd blue--------------------------------------------------------------------------------------------------------------------------------------
09 ------ +24V supply voltage protected for external consumers (via micro fuse F1 (2A)---------------------------------
10 ------ Gnd sync--------------------------------------------------------------------------------------------------------------------------------------
11 ------- not used--------------------------------------------------------------------------------------------------------------------------------------
11 ------- not used--------------------------------------------------------------------------------------------------------------------------------------
13 ------ Hsync------------------------------------------------------------------------------------------------------------------------------------------
14 ------ Vsync------------------------------------------------------------------------------------------------------------------------------------------
15 ------ +5V supply voltage protected for external consumers (via micro fuse F2 (2A)
*
-----------------------------------
*:
not connected on PCB 5012V17 and following
**:
not available on PCB 5012V30 and following
Analog video voltage can be set between approx. 0.5V and 1.5V by means of the trimmer R1
(accessible from the front side of the module). Thus long cable dissipations can be compensated. As
a standard 0.7V are set. Attention: voltages over 0.7V can damage the connected monitor!
The 15-pin high-density DSUB socket is used to connect the monitor. The socket is assigned similar
to the socket of an original VGA monitor. All other monitors must be connected via special
connection cables.