Technical data

Hardware
32 VIPA GmbH CP486 ⋅ 00/14
2.5 Installation of the Memory Card Silicon Disk
The memory card is installed by inserting the memory card into the provided plugin socket.The
memory card silicon disk is always set up to address 800000.
2.6 Installation of an Additional Silicon Disk Board
Various additional silicon disk boards are available or in progress. These are provided essentially
for the CP486S and CP486M. They are to be plugged into the PC/AT extension bus /X10, X16 - see
page 20, 21).
The different additional boards can be set up according to the enclosed documentation.
2.7 Numeric Processor Installation (FPU)
The numeric processor is installed by inserting the module into the respective base (IC19)
(Attention: consider module positioning when inserting). Installation should be realized by VIPA or
skilled personnel.
(Note the instructions how to handle with electrostatic sensitive components).
At the system startup the numeric processor is automatically identified. Detailed information you
get in the manual and from the disk (included in the scope of supply). The disk contains also the test
software for the numeric processor.
Factual use of the numeric processor must be configured possibly in the applications software (see
documentation for the applications software).