Technical data

Contents
CP486 ⋅ 00/14 VIPA GmbH 1
Contents
Page
1. Introduction 7
1.1 General 7
1.2 Application Area 8
1.3 Structure and Operation 8
1.4 Block Diagram of CP486 9
1.5 Special Components 10
2. Hardware 12
2.1 Structure of Modules 12
2.1.1 Structure of the Base Module 12
2.1.2 Structure of CP486S Module 14
2.1.3 Structure of CP486M Module 16
2.1.4 Structure of CP486ML Module 18
2.1.5 Structure of CP486L Module 20
2.1.6 Structure of CP486XL Module 22
2.1.7 Diagram of DIP Switches, Jumpers and Plug Connectors 24
2.2 Setting of DIP Switches 26
2.3 Configuration of 24V Power Supply 28
2.4 Installation of Chip Silicon Disk 30
2.5 Installation of Memory Card Silicon Disk 32
2.6 Installation of an Additional Silicon Disk Board 32
2.7 Numeric Processor Installation (FPU) 32
2.8 Interface Installation for VGA Flat Display 33
2.9 Setting of AT Additional Boards 33
2.10 Slots for CP486 in the PC 34
3. Assignment of Sockets and Plugs 37
3.1 15-pin SubD-Socket for Connecting the Monitor 37
3.2 9-pin SubD-Plug with V24 Interface (COM1 and COM3) 38
3.3 9-pin SubD-Plug with 20mA Interface (COM2) 39
3.4 9-pin SubD-Plug with RS422/485 Interface (COM4) 40
3.4.1 Operation as RS422 Interface 40
3.4.2 Operation as RS485 Interface 40
3.5 5/8-pin DIN Socket for Keyboard 42
3.6 25-pin SubD-Socket with Centronics Interface (LPT1) 43
3.7 2-pin Plugin Socket for external 24V Supply 44
3.8 15-pin SubD-Socket with VIPA Diagnostic Interface 44
3.9 Two-Part Clip Connector with AT Bus 45
3.10 PLC Base Plug (48-pin Male Connectors) 47
3.10.1 Base Plug X1 47
3.10.2 Base Plug X2 47