Technical data

Linkage with PLC
114 VIPA GmbH CP486 ⋅ 00/14
Error numbers are dual encoded.
Error number 1 interface occupied by PLC (job runs)
6 interface occupied by CP
QT/N: D KY left byte: reserve
right byte: source module no. (2...255), DB-no. of
the module with data to be transferred is specified
QANF: D KF Initial address in DB (0...32761), the DW-no. is specified from
whichonthedatatobetransferredarefiledintheDB.
QLAE: D KF Number of data words to be transferred (1...504)
PAFE: A BY Markerbyte, in which the PAFE-message is transferred to
PLC program (permitted 0...255)
Error acknowledge message of handling module:
= 0 no error occurred
><0 error occurred, error number in PAFE-Byte:
3 basic bank number is not divisible by 8
5 bank is not synchronized yet by the CP
10 invalid job number (out of 1...127)
12 no DB open for indirect parameterization
13 source module is not existent
14 source module too short
15 QLAE is invalid (out of 1...504)
16 DB for indirect parameterization too short
18 invalid source module no. (out of 2...255)
19 invalid source initial address (out of 0...32761)
20 invalid marker word no. for ANZW (out of 0...198)
Attention:If the bank number of the CP does not coincide with the number parameterized in
this module, the CPU goes in stop with QVZ!
Parameter storage in a DB if parameterization is indirect:
DL DR
A-NR points to the beginning
INSS
A-NR F-NR
DOSP
ANZW
QT/N
QANF
QLAE
PAFE is not parameterizable indirectly
0 can be parameterized at all other formal operands (SS, DOSP, ANZW, QT/N, QANF, QLAE)
because these are not evaluated at indirect parameterization.
Scratch markers used: MB200-255