User manual

1514
REMOTE CONTROL
*
-
V1382TIR, V1382TIRH
NOTE: PRESS [KEY+ID]
(DEFAULT IS “001” FOR ID=1)
PRESS [ENT] TO ACCESS THE MENU
NOTE : THE CAMERA ID IS A 3-DIGIT NUMBER.
Set the Camera iD in the OSD menu. The default
setting is 001. NOTE : If the Camera ID is modied,
you must reset the power for the new settings to
apply. Once you reset the power, the camera will
recognize the new Camera ID.
If you press the KEY Button, the camera display
will turn into the standby image. NOTE : The LED
icker for approximately 20 seconds.
Input the same number used as the Camera ID to
the Remote Controller. After the number has been
input, the LED light will turn on, and the remote
controller will be ready to use. NOTE : The ID
number is 3 digits.
The ZOOM In (+) and ZOOM Out (-) Keys are used
to control the zoom of your camera lens
and to
select the zoom area of alarm function. Select the
area where you wish to observe the movement of
objects.
Select the zoom range by pressing the WIDE (7)
Key. Save the zoom range by pressing the TELE (8)
Key. NOTE: If the zoom range is smaller than the
alarm standby range, the zoom range setting will
not be saved.
1.
2.
3.
4.
5.
■
REMOTE CONTROL Instructions
MODULE OSD MENU
*
-
V1362DIR
EXPOSURE COLOR DAY&NIGHT
BRIGHTNESS
SHUTTER
BLC
AGC
WB MODE D&N MODE
FUNCTION MOTION PRIVACY
MIRROR
SHARPNESS
GAMMA
SLC
HME
DRC
ALARM MASK 1
MASK 2
MASK 3
MASK 4
COLOR SET
SYNC SETUP EXIT
SYNC CAMERA ID
TITLE EDIT
TITLE RESET
TITLE POSITION
DPC SET
LANGUAGE
PC CONT.
EXIT
SAVE & EXIT
FACTORY RESET
Menu Access and Control
Zoom Function Control
Key Button
ID Buttons
Motion Alarm
ON / OFF